Hesse Oxi-Reactive-Top oil for roller coating RO 79810

Our oxide-reactive roller oil develops an attractive natural wood appearance with highly resistant and sustainable protection for your products. The UV-activated system with a natural oil base also features particular scratch resistance and durability with rapid drying times. Industrial processing results in the surface being ready and stackable after just 6 minutes. This ecological product conforms with the requirements for naturalness according to ÖNORM C 2380.
Request product Download data sheet
  • Description
  • Information on use
  • Sample process
  • Safety Data Sheets / Certificates

Fields of application

For coating panelling and flooring made from all typical types of wood. This product is used on surfaces where the natural character of the wood is to be preserved. Not suitable for smoked oak and thermally treated wood.

Technical specifications

Appearance colourless
Density series kg/l 1.101
Flow time (+/- 15 %) 69 s / DIN 53211 - 4 mm
Form of delivery fluid
Non-volatile content series % 79.8
VOC EU % 19.71 %
Number of coats (max) 2
Amount per layer (minimum) 4 g/m²
Amount per layer (max) 15 g/m²
Total application volume 25 g/m²

Information on use

Stackable after 24 h
Curing

Feed rate 15 m/min

2 to 3 UV-HG lamps at 80 W/cm – 120 W/cm for activation

Substrate sanding grits from-to 120 - 240
Lacquer sanding (grit) from - to 320 - 400
Comments on sanding The quality and uniformity of the substrate sanding and lacquer sanding are crucial to the final surface quality. After sanding, remove dust as prescribed.
Yield per coat 73 - 275 m²/l

The spreading rate is heavily dependent on the type of application. The specifications relate to a liter of ready-for-use product, if necessary including hardener and thinner.
Storage temperature 10 - 35 °C
conditions of transport frost-free - up to a maximum of 35 °C
Processing instructions


Particular instructions The measured gloss level depends on the application quantity, application process, activation parameters and the condition of the substrate.
General instructions on workmanship Clean lamps and reflectors on a regular basis using a soft, lint-free cloth and UV 7111.
Only touch the lamps when wearing cotton gloves. Note the lamp's operating hours and replace them as per the lamp manufacturer's recommendations. Always protect open containers from the incidence of light (cover them).
Seal containers properly after use.
Sufficient lacquer sanding and inspection of the bond within the entire structure will be required in each case. Please apply a trial coating under practical conditions!

The coating process and the precise treatment parameters are adapted in each case to the respective application and drying conditions and can be found in the customer-specific process descriptions (surface techniques).

Contact

Our technical information is continually adapted to keep up to date with the latest technology and statutory regulations. The latest version is always available online at www.hesse-lignal.de or talk to your local account manager. This information is for advice and is based on the best knowledge available and careful research in line with the current state of the art. This information cannot be held as legally binding. We also refer you to our terms and conditions of business. Safety data sheet is provided in accordance with EC regulation no. 1907/2006.