Fields of application
Hesse PURA-TWIN can be used for all internal fixtures and furniture coatings to build up an open-pored surface finish on common European deciduous and coniferous woods.
Technical specifications
| Appearance |
colourless
|
| Density series kg/l |
0.894 - 0.928
|
| Flow time (+/- 15 %) |
50 s / DIN 53211 - 4 mm
|
| Form of delivery |
fluid
|
| Non-volatile content series % |
23 - 26
|
| Proportion of renewable raw materials % |
0.5 - 1
|
| VOC EU % |
74.739998 %
|
| Number of coats (max) |
3
|
| Amount per layer (minimum) |
80 g/m²
|
| Amount per layer (max) |
150 g/m²
|
| Total application volume |
350 g/m²
|
Information on use
| Drying |
30 min / 20 °C
|
| Stackable after |
> 2 h / 20 °C
|
| Complete drying |
6 h / 20 °C
|
| Surface preparation |
Prior to application, the surface must be sanded, clean and free of grease. Clean and dry wood is the prerequisite for a faultless coating.
|
| Substrate sanding grits from-to |
150 - 180
|
| Lacquer sanding (grit) from - to |
280 - 320
|
| Finishing |
After sufficient drying and immediately after interim sanding with lacquer from the same product range.
|
| Yield per coat |
6 - 11 m²/l
The spreading rate is heavily dependent on the type of application. The specifications relate to a liter of ready-for-use product, if necessary including hardener and thinner.
|
| Storage temperature |
10 - 30 °C
|
| Working temperature |
20 °C
|
| Processing instructions |
You can apply two or three coats at 80 - 150 g/m². The maximum application amount in wet film totals 350 g/m2. The following Hesse hardener types can be used to improve the water and PVC resistance of PURA-TWIN: mixing ratio 25 : 1 by volume with DR 470 / DR 4070 or mixing ratio 50 : 1 with DR 471 / DR 4071. In each case the pot life is 5 h at 20 °C. Older hardener-lacquer mixtures no longer offer the desired resistance!
|
| General instructions on workmanship |
Please test the lacquer under real conditions, if necessary.
|
The coating process and the precise treatment parameters are adapted in each case to the respective application and drying conditions and can be found in the customer-specific process descriptions (surface techniques).
Material Safety Data Sheets
Contact
Our technical information is continually adapted to keep up to date with the latest technology and statutory regulations. The latest version is always
available online at www.hesse-lignal.de or talk to your local account manager. This information is for advice and is based on the best knowledge
available and careful research in line with the current state of the art. This information cannot be held as legally binding. We also refer you to our
terms and conditions of business. Safety data sheet is provided in accordance with EC regulation no. 1907/2006.
