Hesse UV Top coat for roller coating UU 75830 Diamond finish

  • very resistant against scratching
  • dull matt
  • with a velvety feel
UV curing product based on unsaturated acrylic resin, dull matt, ready for use. Finishing lacquer for open-pore to closed-pore constructions with particularly good scratch resistance.
Request product Download data sheet
  • Description
  • Information on use
  • Sample process
  • Safety Data Sheets / Certificates

Fields of application

for furniture for interior decoration, doors, etc., as a final coating for particularly stressed surfaces.

Technical specifications

Yield per coat 103 - 247 m²/l

The spreading rate is heavily dependent on the type of application. The specified theoretic spreading rate reduces by up to 40 % with spray applications. Brushing or manual application methods are virtually loss-free. The specifications relate to a liter of ready-for-use product, if necessary including hardener and thinner.
Appearance colourless
Density series kg/l 1.236
Flow time 48 s / DIN 53211 - 6 mm
Form of delivery fluid
Non-volatile content series % 98.7
Profile of properties Diamond seal
VOC EU % 1.29 %
Number of coats (max) 2
Amount per layer (minimum) 5 g/m²
Amount per layer (max) 12 g/m²
Total application volume 20 g/m²

Information on use

Stackable after stackable directly after UV curing
Curing Hardening by means of ultraviolet rays with mercury UV-lamps.Sufficient radiation energy must be provided. This depends primarily on the type, conditions, age and design of the lamp system, so that the optimum UV lamp settings can be implemented on the respective system, and the curing should be checked. Your Hesse representative will assist you with the determination of the necessary radiant energy.
Surface preparation The substrate must be dry, dust-free and grease-free.Pre-priming with coordinated products required.
Substrate sanding grits from-to 400 - 600
Intermediate lacquer sanding (grits) from-to 400 - 600
Comments on sanding Sanding is required to achieve good adhesion to the substrate depending on the substrate’s condition. Wood substrates should be sanded at 120 - 220 grit subject to wood type. Membrane substrates and basecoats should be freshly sanded at 320 - 600 grit. Dust should be carefully removed from the substrate after sanding. Intermediate sanding should generally be omitted when the bond is established when using a primer or the gelling process.
conditions of transport frost-free - up to a maximum of 35 °C
Processing instructions Regularly check the specified application quantities. Clean rollers using suitable thinners!
Particular instructions The measured gloss level depends on the application quantity, application process, activation parameters and the condition of the substrate.
General instructions on workmanship Clean lamps and reflectors on a regular basis using a soft, lint-free cloth and UV 7111.
Only touch the lamps when wearing cotton gloves. Note the lamp's operating hours and replace them as per the lamp manufacturer's recommendations. Always protect open containers from the incidence of light (cover them).
Seal containers properly after use.
Sufficient lacquer sanding and inspection of the bond within the entire structure will be required in each case. Please apply a trial coating under practical conditions!

The coating process and the precise treatment parameters are adapted in each case to the respective application and drying conditions and can be found in the customer-specific process descriptions (surface techniques).

Material Safety Data Sheets

Contact

Our technical information is continually adapted to keep up to date with the latest technology and statutory regulations. The latest version is always available online at www.hesse-lignal.de or talk to your local account manager. This information is for advice and is based on the best knowledge available and careful research in line with the current state of the art. This information cannot be held as legally binding. We also refer you to our terms and conditions of business. Safety data sheet is provided in accordance with EC regulation no. 1907/2006.