Hesse UV Colour Top coat for roller coating UB 7512x(gloss level)-(colour tone)

UV-activated product based on unsaturated acrylate binder, with a tinted glaze, ready to use.
Top coat for a coloured, closed-pore lacquer finish with a pleasant feel to the surface.
Request product Download data sheet
  • Description
  • Information on use
  • Sample process
  • Safety Data Sheets / Certificates

Fields of application

For coating residential furniture, doors, etc. with suitable basecoat in the system structure.

Technical specifications

Appearance glazing
Density series kg/l 1.265 - 1.332
Flow time 58 s / DIN 53211 - 6 mm
Form of delivery fluid
Non-volatile content series % 97.2 - 98.8
VOC EU % 2.45 %
Number of coats (max) 2
Amount per layer (minimum) 3 g/m²
Amount per layer (max) 6 g/m²
Total application volume 12 g/m²

Information on use

Curing

A coating structure without lacquer sanding can be achieved using the gelling procedure.
Gelling:
1 Ga and 1 Hg lamp, 80 W/cm, V = 15 - 20 m/min
UV curing:
1 Ga and 1 Hg lamp, 80 W/cm, V = 5 - 7 m/min

Intermediate sanding (grits) from-to 400 - 500
Comments on sanding The quality and uniformity of the substrate and lacquer sanding are crucial to the final surface quality. After sanding, remove dust as prescribed.
Yield per coat 216 - 433 m²/l

The spreading rate is heavily dependent on the type of application. The specifications relate to a liter of ready-for-use product, if necessary including hardener and thinner.
Storage temperature 16 - 25 °C
conditions of transport frost-free - up to a maximum of 35 °C
Processing instructions Single- to double-coat application with hard or soft grooved roll 5 - 8 g/m² on suitable primers.
Maximum total application amount in wet film: 16 g/m².
Particular instructions Pre-priming with coordinated products required.
General instructions on workmanship Clean lamps and reflectors on a regular basis using a soft, lint-free cloth and UV 7111.
Only touch the lamps when wearing cotton gloves. Note the lamp's operating hours and replace them as per the lamp manufacturer's recommendations. Always protect open containers from the incidence of light (cover them).
Seal containers properly after use.
Sufficient lacquer sanding and inspection of the bond within the entire structure will be required in each case. Please apply a trial coating under practical conditions!

The coating process and the precise treatment parameters are adapted in each case to the respective application and drying conditions and can be found in the customer-specific process descriptions (surface techniques).

Material Safety Data Sheets

Contact

Our technical information is continually adapted to keep up to date with the latest technology and statutory regulations. The latest version is always available online at www.hesse-lignal.de or talk to your local account manager. This information is for advice and is based on the best knowledge available and careful research in line with the current state of the art. This information cannot be held as legally binding. We also refer you to our terms and conditions of business. Safety data sheet is provided in accordance with EC regulation no. 1907/2006.